Datagate MK2 firmware Release-notes 4 Oct 2017 - New (revB): DHCP mode supports Fallback to static IP address (on startup) - active by default - Fix (revB): DHCP Failure, no longer locks out changing IP address. - Fix (revB): U-boot updated to fix a random boot failure (LCD stuck on ENTTEC) - New (revB): U-boot version now shown on Home-page 11 July 2017 - Fix: Priority Merge - no output in some cases - Fix: Priority Merge - correctly identifies if primary source is alive. - Firmware downgrade is now possible on revB units (password = hardware_id + last 2 digits of mac_add) June 2017 - Fix: ArtSync was causing delayed DMX output in some scenarios - minor bug fixes April 2017 - Fix: Merging rule was broken sometimes, now fixed - Fix: LCD Menu IP address changes and Factory reset - Fix: New IO Driver Version: 3.2 (reliable DMX In/Out) Feb 2017 - New: Art-Sync support enabled. (4 second idle timeout applies) - Fix: Allows sufficent time for Network initialization at startup - Fix: IP Address changes are now reflected properly in Poll replies. - Fix: Backup/Restore between revA and revB units (both should be on this latest firmware) Nov 2016 - Smart copy feature added to profiles page (shift universes, while copying profiles) - Art-Net 3 supported. To change Art-Net 3 Net address, please use Settings page. Combined universe shown in profile editor for simplicity. - sACN Universe limit increased to 999. - revB units supported with this firmware. - revB units allow Fan control from Settings page (no password needed) - minor bug fixes Oct 2014 - bug-fix: sACN fixes and merging support allowed by using different sacn id - bug-fix: profile editor - modules order always preserved June 2014 - bug fix: enhanced performance with Clock module - bug fix: D-PRO module updated to support 1.4 - bug-fix: sACN prioirty selection from 0-200 allowed - new feature: DMX or Ar-Net or sACN snapshot (available from DMX Source screen - snapshot can be saved as DMX source) - new feature: stream-peek (available from stream auditor screen) Nov 2013 - bug-fix: unable to change profiles after updating from old firmwares Sep 2013 - **critical** fixes possible NAND file system corruption - minor interface changes - bug-fix: Profile editor Sep 2012 - supports offline use - as DMX Hub (no ethernet required) - fixed Art-Net node reply as per protocol - bug-fix: DMX Generator June 2012 - added Touch OSC support - added D-PRO show support (license required) - added sACN support - added Compressor module - minor bug fixes